12 Advisor Advanced ATSx500A User Guide
Unset areas via keypad without LCD
To unset areas via keypad without LCD:
1. Enter the premises using the designated entry/exit route.
An intermittent entry tone starts.
2. Provide an allowed key sequence indicated in “Common key sequences” on
page 28.
The entry buzzer stops and the areas are unset.
LEDs are extinguished.
Autoset
The system can be configured so that the premises are set automatically at a
particular time and a day of the week.
Before the autoset begins, the warning time starts. The system may warn the
users by a sound. The following message is displayed:
Depending on system settings and user privileges, you can postpone the autoset
during the warning time. To do this, press Clear and authorize.
The system manager will inform you for what time the autoset can be postponed.
Areas displayed during set and unset
If your system has not been programmed to display the areas assigned to your
PIN on the LCD, those areas are automatically set/unset (provided all zones
were normal).
The area LEDs illuminate when the set or unset procedure is successful.
If you are authorized to operate both on areas and area groups, you will be
prompted to choose between areas and area groups.
Choose between areas and area groups, and then press Enter.
Area list
If the areas assigned to your PIN are displayed, any of those areas that are set
(or unset) will be listed. Depending on the keypad model and its settings, areas
are shown as a list or a symbolic line. For example:
— or —
To Next Page
Loading...
