Chapter 3: System functions
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 95
5. Press the programming key sequence to activate the fob. See “Device
activation” on page 97 for more information about activation.
If an error occurs, the keypad shows an error message and beeps seven times.
The error can occur, for example, when you try to learn a fob, which is already
programmed in the wireless expander.
If the fob is programmed successfully, the keypad shows an information
message and beeps once.
If there are more fobs to program, and there are fob inputs available in the
wireless expander, repeat learning another fob.
To stop the learning process and exit the menu, press Clear.
Proceed with the fob configuration.
Manual mode
In manual mode, you can learn and configure a fob.
To learn a fob in manual mode:
1. Go to the “4.4.0 Add fob” menu described on page 191.
1>Expander 1
2 Expander 2
2. Select zone location.
3. Choose Manual mode and press Enter.
4. Enter the input number.
If the input is free, you are prompted to activate the wireless device.
Program fob 1
Press # for ID
To Next Page
Loading...
Need help?
General
