Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 123
• LS: Long supervision alarm
• D: Fire sensor is contaminated
1.2.1.5 Cam range test
17 Camera 17
18 Camera 18
Range test allows you to verify wireless PIR camera signal reception.
Select a camera to activate range test.
In this mode, selected wireless PIR cameras show the reception quality with
alarm LED colour:
• Green: Good signal
• Orange: Medium signal
• Red: Weak signal
The LED follows the weakest communication link of LDR and HDR.
For more information on the communication quality, refer to the appropriate
wireless PIR camera expander manual.
1.2.1.6 Inactive days
The inverted walk test function is performed by watching all zones inactive timers
and deciding whether a long inactivity is caused by a detector fault.
The menu allows you to view inactive day timers for each zone, and to reset all
zone timers.
Every time a zone becomes active, the inactive day timer is reset for this zone.
The timer range is 0 to 127 days.
Press 0 to reset all inactive day timers.
Choose a zone to view its timer.
See also “8.1.4.7 Inactive days” on page 236.
1.2.1.7 Zone kOhm
The menu allows you to monitor zone resistances.
Select the input location first (panel or internal expander). Then enter the
(physical) input number on this location.
To Next Page
Loading...
Need help?
General
