Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 139
The demo mode is cancelled:
• Automatically after 15 minutes
• When the option is switched off
• When the system is restarted
The mode can be only activated via keypad.
Note: The demo mode should be activated only when all areas are unset.
1.2.13 Door control
The menu allows you to send a direct command to a specific door.
• 1 Door open: Open a specific door for a period configured for this door. See
“5.1.n.5.1 Unlock time” on page 198.
• 2 Door lock: Lock a specific door.
• 3 Door unlock: Unlock a specific door until Door lock command is sent.
• 4 Door disable: Disable a specific door. This makes access for all users
denied.
• 5 Door enable: Enable a disabled door.
Select a command, then select a door from the door list, and press Enter.
1.3 Software Mgmt
1>Software rev
2 Panel language
The informational screens provide information on the panel firmware and initial
settings.
1.3.1 Software Rev
ATS1000A 1.0
TR_008.008.0028
The Software Revision menu lets you view information of the version number of
the panel firmware.
1.3.2 Panel language
The screen shows panel language set during installation.
See “Initial start-up” on page 114 for details.
1.3.3 Defaults
The screen shows panel defaults set during installation.
See “Initial start-up” on page 114 for details.
To Next Page
Loading...
Need help?
General
