Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 177
4.1.n.6.18 Key unset
If the Key unset option is set to Yes, the zone is a key switch that unsets an area.
4.1.n.6.19 Technical full set
If the Technical full set option is set to No, the technical alarms in this zone are
disabled when the area is fully set.
4.1.n.6.20 Technical unset
If the Technical unset option is set to No, the technical alarms in this zone are
disabled when the area is unset.
4.1.n.6.21 Technical part set
If the Technical part set option is set to No, the technical alarms in this zone are
disabled when the area is partially set.
4.1.n.6.22 Keypad LCD
If the Keypad LCD option is set to Yes, when the zone activates, the zone name
is displayed on the keypad LCD on all keypads, related to the area.
4.1.n.6.23 Log
The Log option determines whether the zone event is recorded in the system log.
4.1.n.6.24 CS report
The CS report option determines whether the zone event is reported to the
central station.
To Next Page
Loading...
Need help?
General
