Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 243
• 6 Interconnection fault: A critical error caused by communication trouble
between internal panel components
• 7 Mains fault: Mains fault, including external fault
• 8 Battery fault: Battery fault, including external fault
• 9 FTC (Failed to Communicate): Alarm reporting has failed to deliver events
• 10 Siren fault: Siren output fault
• 11 Zone technical: Technical zone status
• 12 Keypad fault: A fault reported by keypad
• 13 Expander fault: A fault reported by remote expander
• 14 Comms fault: All transmission paths are down (no communication)
• 15 Engineer reset: Engineer reset requirement
• 16 Alarms pending: Unacknowledged alarms
8.4.2 Inhibit includes
1>Zone panic
Access level 3
The menu defines which conditions a user with particular access level is allowed
to inhibit. If a particular condition below has this option set to Access level 2 or
Access level 3, a user with this access level can inhibit it using an inhibit menu or
during set.
The following options are available.
• 1 Zone panic: Holdup device active
• 2 Zone masking: Masking / fault state on input
• 3 Zone fault: Intrusion detector fault
• 4 Zone tamper: Tamper in zone
• 5 Interconnection fault: A critical error caused by communication trouble
between internal panel components
• 6 Mains fault: Mains fault, including external fault
• 7 Battery fault: Battery fault, including external fault
• 8 FTC (Failed to Communicate): Reporting attempts are failed
• 9 Siren fault: Siren output fault
• 10 Zone technical: Technical zone status
• 11 Keypad fault: A fault reported by keypad
• 12 Expander fault: A fault reported by remote expander
• 13 Comms fault: All transmission paths are down (no communication)
• 14 Engineer reset: Engineer reset requirement
8.4.3 Part set
The Part set menu allows you to configure the part set options.
To Next Page
Loading...
Need help?
General
