Chapter 5: Menu reference
262 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
9.1.n.8.1.5 SIA frequency
The SIA frequency menu allows you to select one of two standards for modem
communication regarding transmitted/received frequencies used by
transmitter/receiver.
This option allows you to select between CCITT and BELL.
9.1.n.8.2 VOICE
The VOICE menu allows you to configure voice reporting options listed below.
9.1.n.8.2.1 Suppress FTC
If the Suppress FTC option is set to Yes, no FTC fault is activated for this central
station when the voice protocol is used.
9.1.n.8.2.2 Without ACK
If the Without ACK option is set to Yes, a recipient of a voice message does not
need to acknowledge the message.
Otherwise, he must acknowledge it by pressing a phone key using tone dialing
mode. The panel tries to retransmit the message until it is acknowledged.
9.1.n.9 OP/CL report
9 OP/CL report
>Separate<
The OP/CL report option defines if opening and closing is reported for all areas
with the same account code, or for each of those. The following options are
available:
• Combined: When all areas with the same account code are armed, a closing
is reported using the area and user who armed it. An opening is reported only
when the first of the areas with the same account code is disarmed.
• Separate: For any of areas with the same account code a closing and an
opening is reported. The area modifier indicates the area concerned (see
“9.1.n.8.1.1 Area modifier” on page 261).
Note: When (X)SIA protocol is selected, separate reporting works only when SIA
area modifier is enabled.
See “9.1.n.5 Accounts” on page 259 for more details.
To Next Page
Loading...
Need help?
General
