Chapter 5: Menu reference
178 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
4.1.n.6.25 Delay timer
A delay timer is activated for this zone if the Delay timer option is set to Yes. The
delay timer is set in “8.1.4.4 Input delay” (see page 236).
4.1.n.6.26 ACK on keypad
26 ACK on keypad
>Keypad 1<
Acknowledge options are available for keyswitch zone type. They allow you to
define a keypad where the particular user is logged in automatically. This causes
that an alarm and fault information is displayed instantly on the selected keypad.
The ACK session opens for 2 minutes. During this time you can acknowledge the
alarm on the programmed keypad.
Note: “4.1.n.6.27 ACK by user” below must be also set for the acknowledgement
functionality to work.
4.1.n.6.27 ACK by user
The option defines the user that is logged in automatically when the selected
zone causes an alarm.
Note: “4.1.n.6.26 ACK on keypad” above must be also set for the
acknowledgement functionality to work.
See “4.1.n.6.26 ACK on keypad” above for more details.
See also “2.2.1.n.3.17 ACK on keypad” on page 149.
4.1.n.6.28 Sensor type
28 Sensor type
>Low temp.<
The events reported by a technical zone depend on the type of the sensor
connected. The Sensor type option specifies what the sensor is and what events
it should report. The following sensor types are available:
• Low temperature detector
• High temperature detector
• Gas detector
• Water detector
• Fire alarm
• Generic
Table 25 on page 179 lists events that may be reported for each sensor type.
To Next Page
Loading...
Need help?
General
