Chapter 3: System functions
64 Advisor Advanced ATSx500A(-IP) Installation and Programming Manual
[value]: Option is read only.
[1] The value may depend on defaults selected during the initial start-up. See “Initial start-up” on
page 114 for details.
[2] See “User privilege limitation” below for details.
[3] Allowed keypad numbers depend on the panel variant. For details, see “General features” on
page 36.
For detailed descriptions of user group options, see “User group options” below.
User privilege limitation
The User adding option determines whether the user can add new users and
what user rights these newly created users have.
• None: User cannot create new users.
• Restricted: User can create new users, but he is only allowed to set
permissions equal to or lower than his own.
For example, if his user group does not allow changing the date and time, he
cannot provide this permission to any user by editing a user group, nor assign
a user to an existing user group with that permission. This affects options as
well as areas. For example, if the user has access only to Area 1, he cannot
give access to Area 2 to another user.
• All: User can create new users with any permission.
See also “User data lock” on page 61.
User group options
User group options are set in menu “3.2.n.6 User group options” on page 169.
The following options are available.
Table 17: User group options as user privileges
Isolate zones, bus devices, cameras etc.
Change system time and date.
To Next Page
Loading...
Need help?
General
