Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 163
3.1.n.2.1 Change PIN
Change the selected user PIN.
See “PIN” on page 66 for details on PIN usage.
3.1.n.2.2 Remote PIN
Remote PIN is a PIN for programming the panel via remote connection. If remote
PIN is not set, the installer uses local PIN to log in remotely.
Note: This submenu is available for installer only. If the option “8.7.8.2 Remote
PIN” on page 253 allows it, the submenu is also available for the supervisor.
See “Remote access” on page 113 for more details.
3.1.n.2.2.1 Set PIN
Set remote PIN.
To enable remote PIN, use “3.1.n.2.2.2 Enable login” below.
3.1.n.2.2.2 Enable login
Use the command to enable remote PIN.
See “3.1.n.2.2 Remote PIN” above for more details.
3.1.n.3 User card
1>Assign card
Card not set
The User card menu lets you assign or delete a user card.
The content of the menu depends whether a card has been already assigned or
not.
3.1.n.3.1 Assign card
If the user has no card assigned, the menu lets you enter a user card number.
Press Enter and present the card at the keypad within 10 seconds.
To Next Page
Loading...
