Chapter 5: Menu reference
Advisor Advanced ATSx500A(-IP) Installation and Programming Manual 241
8.3 LCD display options
The LCD options menu contains options that can be set for LCDs and menus.
8.3.1 Armed display
If the Armed display mode is Always, the armed display activates after the
programmed idle time. The armed display timeout is programmed in “8.1.3.1
Armed display” (see page 234).
The armed display deactivates when performing any action that requires an
authorization with a valid user code or badge.
You can select one of the following armed display options:
• Off: Armed display is disabled.
• If set: Armed display activates only when the area is set. No status
information is displayed on keypad LCD and LEDs (except mains LED and
Alert message).
• Always: Armed display always activates. No status information is displayed
on keypad LCD and LEDs (except mains LED and Alert message).
• Without code: Armed display always activates. No area LED is lit.
Note: This mode also allows you to deactivate the armed display pressing the
Clear key.
8.3.2 Custom message
The Custom message menu allows you to define a keypad welcome message.
This records 16 characters of customized text that is displayed on the top line of
LCD keypads instead of the default text. Characters include numbers, spaces, or
punctuation.
8.3.3 Alarm list
The option defines how zone alarms and faults can be viewed on LCD by an
unlogged user.
• Disable: Zone alarms and faults are not shown.
To Next Page
Loading...
