12
OTHER KEYPAD FUNCTIONS
SETTING THE KEYPAD TONE
Step 1 Press [ ]-[0]. Keypad is now in the “Adjust Tone” mode.
Step 2 Pressing the [1] key will make the keypad sounder go to higher
tones, pressing the [2] key will make the keypad sounder go to lower tones.
Step 3 When the desired tone is reached, press the [#] key to set this tone
and exit from the “Adjust Tone” mode.
CHANGE PARTITION – Optional
Step 1 Press [ ]-[1].
Step 2 Press a NUMBER key (1 or 2) to change partitions momentarily.
Step 3 If no other key is pressed, it will go back to its standard partition in
ten seconds.
Step 4 If another key is pressed, the system will remain in the new
partition until no keys have been pressed for 60 seconds.
VIEW ALARM MEMORY
Step 1 Press []-[3]. The zone(s) that created the last alarm will be
displayed on the keypad.
Step 2 The ALARM MEMORY feature will flash those zones that created
alarms and will light steady those zones that were bypassed
during the last alarm.
TEST FUNCTION – Optional
If programmed, this function will perform a battery test, communicator test,
and/or a siren test. No alarms will be sent and no reports will be sent unless a
communicator test is performed, at which time a test signal will be sent.
Step 1 Press []-[4]. The test will be performed as programmed.
Step 2 If the siren test is performed, enter a user code to silence the siren.
WALK TEST
If enabled, it will permit a temporary walk-through test where all zones become
silent and do not report alarms to the central station.
Step 1 Press []-[Chime]-[user code]. During this test the chime light will
flash on the LED keypad.
Step 2 Each time a zone is faulted, the zone light on the LED keypad will
illuminate and the chime will sound. The number of the faulted
To Next Page
Loading...
Need help?
General
