Interlogix Simon XT User Manual

Simon XT User Manual 31
To program Piezo beeps, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Siren options, then press Enter.
3. Scroll up/down to Piezo beeps, then press Enter.
4. The current value of this option now flashes (On or Off).
5. Scroll up/down to the desired value, then press Enter.
6. Press STATUS repeatedly to exit.
Panel voice
Panel voice (spoken phrases on the speaker) and key press sounds from the
speaker heard while controlling the system). This option determines whether or
not the panel speaks status messages and arming level changes.
To program Panel voice, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Siren options, then press Enter.
3. Scroll up/down to Panel voice, then press Enter.
4. The current value of this option now flashes (On or Off).
5. Scroll up/down to the desired value, then press Enter.
6. Press STATUS repeatedly to exit.
Panel piezo alarms
Loud alarms on the siren. This option determines whether or not the panel
sounds alarm beeps.
To program Panel piezo alarm, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Siren options, then press Enter.
3. Scroll up/down to Panel piezo alrm, then press Enter.
4. The current value of this option now flashes (On or Off).
5. Scroll up/down to the desired value, then press Enter.
6. Press STATUS repeatedly to exit.
Status beep volume
This option sets the sound volume of nonalarm beeps. The numerical range is 1
to 10. The default value is 7.
To program Status beep vol, do the following:

Interlogix Simon XT Specifications

Power

power requirements	6V nominal
standby current	30mA (10mA in PowerSave Mode)
peak current	1.7 A

Operating Environment

operating temperature	32 to 120°F (0 to 49°C)
storage temperature	-30 to 140°F (-34 to 60°C)
max. relative humidity	90% non-condensing

Dimensions

height	4 1/16 in.
width	1 7/8 in.