32 Simon XT User Manual
1. Enter the System programming menu.
2. Scroll up/down to Siren options, then press Enter.
3. Scroll up/down to Status beep vol, then press Enter.
4. The current value of this option now flashes (1 to 10).
5. Scroll up/down to the desired value, then press Enter.
6. Press STATUS repeatedly to exit.
Speaker volume
This option sets the sound volume of the panel speaker for key presses and
alarm sounds. The numerical range is 1 to 8. The default value is 8.
To program Speaker volume, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Siren options, then press Enter.
3. Scroll up/down to Speaker volume, then press Enter.
4. The current value of this option now flashes (1 to 8).
5. Scroll up/down to the desired value, then press Enter.
6. Press STATUS repeatedly to exit.
Light control
You can control certain lights by using X10 lamp, appliance, or universal
modules. As set up by the installer, these modules have unit numbers from 1 to 8
and are set to the same housecode. These lights can be turned on for certain
arming operations, when a sensor is tripped or based on a time schedule. Light
control includes:
Set entry lights
In this menu, each unit number can be set up as an entry light. These lights flash
the arming level when the system is armed. For example, an entry light flashes
twice when the system is armed to Level 2 (Doors+Windows).
To Set entry lights, do the following:
1. Enter the System programming menu.
2. Scroll up/down to Light control, then press Enter.
3. Scroll up/down to Set entry lights, then press Enter.
4. Scroll up/down to the unit number you want to set up, then press Enter.
5. The current option value flashes (On or Off).
6. Scroll up/down to the desired value, then press Enter.
To Next Page
Loading...
Need help?
Power
Operating Environment
