10 TruPortal Dual Door Interface Module Quick Reference
Specifications
The TruPortal Dual Door Interface Module is for use in low
voltage, Class 2 circuits only. These specifications are subject to
change without notice.
Specifications
Regulatory Information
Contact Information
www.interlogix.com
Customer support: www.interlogix.com/support
© 25JUL13 United Technologies Corporation
Interlogix is part of UTC Climate Controls & Security, a unit of
United Technologies Corporation. All rights reserved.
Document number: 460802001C - July 2013
Dimensions 5.75 x 4.25 x 1 in. (146 x 108 x 25 mm)
Operating
environment
Temperature: +32 to +120° F (0 to +49° C )
Humidity: 5 to 85% RHNC at 77° F (25° C)
BTU Output: 12.3 BTU/hour
Incoming power
ratings
12 VDC, 300 mA max
Outputs Four outputs: Relay type
Door strike: 24 VDC/1 A
Aux: 24 VDC/0.1 A
Inputs Eight unsupervised/supervised, standard EOL, 1k/1k
ohm, 1% 1/4 watt
One unsupervised, dedicated for enclosure tamper
Reader interface Four interfaces
Reader power (jumper selectable): 12 VDC +
10%
regulated, 125 mA maximum each reader or 5 VDC +
10% regulated, 600 mA maximum each reader
Communication SNAPP bus (RS-485)
Cable requirements
Power: 18 AWG (1.024 mm / 0.823 mm
2
), one
stranded
Reader data: six conductors, 18 AWG (1.024 mm /
0.823 mm
2
), 500 feet (150 m) maximum
SNAPP bus (RS-485): 22 AWG (0.644 mm / 0.326
mm
2
), 100 ohm impedance, twisted pair with shield,
4000 feet (1219 m) maximum
Manufacturer Interlogix
Headquarters and Regulatory responsibility:
Interlogix
3211 Progress Dr.
Lincolnton, NC 28092 USA
EU authorized manufacturing representative:
UTC Climate, Controls & Security B.V.,
Kelvinstraat 7, 6003 DH Weert,
The Netherlands
Year of
manufacture
The first two digits of the product serial number (located
on the product identification label) are the year of
manufacture.
North American
standards
UL 294
FCC
compliance
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
Certifications RoHS compliant, WEEE
European Union
directives
We declare under our sole responsibility that this product
is in conformity with Directive 1999/5/EC (R&TTE), 2004/
108/EC (EMC), 2006/95/EC (LVD), and 93/68/EEC
(Marking) based on test results using harmonized
standards in accordance with the Directives mentioned.
To Previous Page
Loading...
