2BChapter 3: Network and streaming configuring
To define the network parameters:
1. In the “Network Parameters” folder click the Network setting subfolder to
open its screen.
From the NIC Type drop-down list, select the required value. Enter the values
for the IP address, subnet mask, gateway, DNS server and HTTP port. Click
Save to save changes.
2. Click the PPPoE setting subfolder to open its screen and check Enable
PPPoE. Enter the user name and password. Click Save to save changes.
3. Click the DDNS setting subfolder to open its screen and check Enable
DDNS. Enter either IP server or DynDNS as protocol.
If DynDNS is selected, enter the user name and password registered to the
DynDNS web site. The domain name is that of the DynDNS web site. Click
Save to save changes and return to the “Network settings” menu.
4. Click the E-mail setting subfolder to open its screen and enter the SMPT
server, SMTP port, user name and password and the e-mail sender and
receiver addresses. Click Save to save changes.
Serial port settings
Use the “Serial setting” folder to define the RS-232 and RS-485 communication
settings.
If a PTZ camera is connected to this camera, the RS-485 settings must be the
same as the PTZ protocol used.
TruVision IP Do
me Open-Standards User Manual 25
To Next Page
Loading...
