50 TruVision Series 3 IP Camera FW3.1 Configuration Manual
To set up a NAS system:
1. Click Configuration > Storage > NAS.
2. Enter the IP address of the network disk, and the NAS file path.
3. Click Save to save changes.
Storage devices
Use the storage management window to display the capacity, free space
available and the working status of the HDD of the NAS and the SD card in the
camera. You can also format these storage devices.
Before formatting the storage device, stop all recording. Once formatting is
completed, reboot the camera as otherwise the device will not function properly.
If Overwrite is enabled, the oldest files are overwritten when the storage
becomes full.
To format the storage devices:
1. Click Configuration > Storage > Storage Management.
2. Check the HDD Number column to select the storage.
3. Define the quota percentage for snapshots and recordings, modify the values
for each in Percentage of Snapshot and Percentage of Record.
4. Click Format. A window appears to check your formatting permission.
5. Click OK to start formatting.
Recording schedule
You can define a recording schedule for the camera in the “Record Schedule”
window. The recording is saved on to the SD card or NAS in the camera. The
camera’s SD card provides a backup in case of network failure.
The selected recording schedule applies to all alarm types.
To Next Page
Loading...
