Need help?Do you have a question about the Interlogix TVT-5304 and is the answer not in the manual?
General| Resolution | 1920 x 1080 |
|---|---|
| Image Sensor | 1/2.8" Progressive Scan CMOS |
| Sensor Type | CMOS |
| Minimum Illumination | 0.01 Lux @ (F1.2, AGC ON), 0 Lux with IR |
| Day/Night | IR cut filter with auto switch |
| Compression | H.264, MJPEG |
| Network Interface | 10/100 Mbps Ethernet |
| Power Supply | 12 VDC ± 10%, PoE (802.3af) |
| Ingress Protection | IP66 |
| Lens | Fixed |
| Frame Rate | 30fps (1920 × 1080) |
| Operating Temperature | -30°C to 60°C (-22°F to 140°F) |
Guide for setting a password and activating the camera using a web browser.
Instructions for activating the camera using TruVision Device Manager software.
Defines camera name, SN, firmware version, time, and serial port settings.
Sets up network parameters for camera access over the internet.
Adjusts image parameters like brightness, contrast, and day/night mode.
Configures IP address, subnet mask, gateway, DNS, and other network parameters.
Sets HTTP, RTSP, HTTPS, and server port numbers for camera communication.
Adjusts video stream type, resolution, quality, frame rate, and audio input/output.
Modifies brightness, contrast, saturation, sharpness, and exposure settings.
Defines detection areas, sensitivity, and arming schedules for motion-triggered alarms.
Detects objects crossing a defined line with specified direction and sensitivity.
Defines defense regions and triggers alarms when objects enter or loiter within them.
Defines continuous, motion-triggered, or alarm-triggered recording schedules.
To Next Page
