To Next Page
B
brownjeanetteAug 1, 2025
What to do if Interlogix Control Panel network connections fail?
- KKathleen PierceAug 1, 2025
If your Interlogix Control Panel is failing to establish network connections, first check if your Wi-Fi router allows both b and g connections. Some newer routers might have these turned off by default, and some 802.11n access points might not accept 802.11g connections. Also, ensure your router is within range and has a strong signal. If not, a Wi-Fi range extender could help. Verify that auto-correct is turned off when entering the pass phrase, and that your wireless router has DHCP enabled. Make sure your wireless router doesn't have firewall or security rules blocking additional connections. Finally, confirm that IP addresses are available by connecting a new device to the router and checking its internet connection.
General
