Need help?Do you have a question about the Intermatic T103 and is the answer not in the manual?
General| Amperage | 40A |
|---|---|
| Horsepower Rating | 2 HP |
| Number of Poles | 1 |
| Minimum Time Setting | 30 minutes |
| Mounting | Surface |
| Housing Material | Metal |
| Number of Trippers | 2 |
| Enclosure Type | NEMA 1 Indoor |
Details resistive, inductive, and pilot duty ratings for 120/208.240V AC, and HP ratings for 120V and 240V AC.
Specifies voltage (110-125V) and frequency (60Hz) for the clock motor, and ordering information for replacements.
Guidance on selecting copper wire size, load capacity, and insulation temperature ratings for installation.
Instructions for setting the desired ON and OFF times using the trippers on the CLOCK-DIAL.
Procedure to set the current time-of-day on the CLOCK-DIAL by pulling and turning it to align with the pointer.
How to manually operate the switch using the MANUAL LEVER, independent of programmed times.
Instructions for resetting the CLOCK-DIAL to the correct time after an electrical power failure.
