Turn the printhead lift lever clockwise to raise the printhead.
Get the roll of thermal transfer ribbon from the EasyADC shipping box.
Unpack the PM4i and its box of printer accessories.
Get these items from the Printer Accessories box:
• high edge guide (teal)
• AC power cord
The other items in the Printer Accessories box are described in the user’s guide.
Set these items aside for now.
Note: The sample media and ribbon in the printer box are not
intended for use with the EasyADC System. Do not use them in
this installation.
Get the 3.05 m (10 ft) Ethernet cable from the EasyADC Accessories box. Or,
get your own Ethernet cable if you need a longer cable run.
Connect the AC power cord to an AC outlet and the back of the PM4i.
Connect the Ethernet cable from your network hub or switch to the Ethernet
port on the back of the printer.
Open the printer front and side doors.
Installing the PM4i
STEP 6
To Next Page
Loading...
