Manually advance the ribbon until all of the metallic leader has passed the
printhead and the ribbon becomes tight.
Remove the installed low edge guide:
a. Tilt the low edge guide so it is parallel to the mounting arm.
b. Pull the edge guide toward the front of the printer and unhook the guide
by rotating it counterclockwise as seen below.
Turn the printhead lever clockwise to release the ribbon.
Installing the PM4i (continued)
Bring the end of the ribbon back over the printhead and around the
cardboard takeup roll. Press the adhesive end of the ribbon onto the roll,
making sure to line up the sides of the ribbon with the edges of the core.
STEP 6
To Next Page
Loading...
