Intermec CK61 - Connecting to the Top Battery Terminal

10 Vehicle Dock Kit Installation Instructions
Repeat Steps 2 through 8 for the negative (brown) wire from the
battery cable, hooking up the negative cables to the negative (-)
battery terminal.
Connecting to the Top Battery Terminal
1 Remove the battery clamp posts from the vehicle battery
terminals.
2 Replace the battery clamp posts removed in Step 1 with 5/16"
x 1-1/2" posts and nut furnished in the installation kit.
Tighten nut securely.
3 Slip a 3/8" washer
onto the extended end of each battery
clamp bolt.
4 Slide the positive (red wire) fuse link terminal ring from the
battery cable onto the positive (+) battery clamp bolt.
5 Slip a second 3/8" washer onto the battery clamp bolt.
6 Thread a second 3/8" nut onto the battery clamp bolt.
7 Tighten the nut.
Because electrical energy from vehicle batteries can
harm equipment and people, it is very important to
make sure that you make the correct cable to
battery connections.
Battery
Positive battery post
Positive battery cable
Fuse link
Brown wire (negative)
Power cable
Red wire (positive)
Batttery terminal
post (positive)
Nut
Washers