12 Vehicle Dock Kit Installation Instructions
Verifying the Dock Power Cable Polarity
Below are the pin descriptions for the notched DC power
connector on the dock power cable. Use a volt meter to verify
whether +12 volts is on pin 2 before you make the final cable
connection.
Vehicle Dock Power Cable 3-Pin Male Power Connector
Performing the Final Connections
1 Connect the keyed rectangular connector end of the dock
power cable P/N 236-105-001 to the previously installed gray
battery cable.
2 Attach the circular notched DC power connector of the dock
power cable to the installed vehicle dock.
Use this illustration to verify that you have
installed your vehicle dock power cables correctly.
Pin 3, ground
Pin 1, chassis ground (optional)
Pin 2, 12 volts
To Next Page
Loading...
