Vehicle Dock Kit Installation Instructions 15
To modify the black dock cable to connect into a vehicle fuse block
• Switch to using the fuse block cable P/N 226-109-003, or
Cut off the white connector from the end of the dock power
cable and wire it directly to the fuse block.
Jump-Starting Your Vehicle
Always disconnect the power cables from the dock and printer
before attempting to jump-start your vehicle.
Note the difference in polarity between these two
cables.
Wiring for Fuse Block Cable and Dock Power Cable
Cable White Wire Black Wire
Dock power (black) P/N 236-105-001 Negative Positive
Fuse block (gray) P/N 226-109-003 Positive Negative
Failure to follow these instructions may result in
damage to your mobile computer equipment.
To Next Page
Loading...
