Chapter 1 — Using the CN4
CN4 Mobile Computer User’s Manual 5
To change the battery
1 Press and release the Power button to suspend the CN4.
2 Unsnap the top end of the handstrap.
3 Slide the tab on the battery to release it from the CN4.
4 Place the end of the battery into the battery compartment as
shown in the next illustration, and press down on the other end of
the battery until it clicks into place.
5 Snap the top of the handstrap into place.
Note: For the CN4NI, use a Phillips screwdriver to loosen and
tighten the battery set screw.
To Next Page
Loading...
