Intermec CN4

Chapter 2 — Connecting and Configuring the CN4
CN4 Mobile Computer User’s Manual 63
8 For Pre-Shared Key, enter the pre-shared key or passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the access point. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the CN4 internally converts it to a
pre-shared key.
This value must match the passphrase on the authenticator.
9 Save your settings.
Configuring 802.1x Security With Funk Security
1 Make sure the communications and radio parameters on your
CN4 are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose Open.
7 For Encryption, choose WEP.
8 For 8021x, choose TTLS, PEAP, or TLS.
9 If you chose TTLS or PEAP:
a Enter a User Name.
b For Prompt for Credentials, choose Enter credentials now.
c Enter a User Password.
d For Validate Server Certificate, choose Yes.
If you choose TLS:
a Load a user and root certificate on your CN4. For help, see
“Loading a Certificate” on page 68.
b For Validate Server Certificate, choose Yes.
c Enter a User Name and Subject Name.
Note: You can use Prompt for Credentials to troubleshoot
your network connection.