4 CV60 Recovery CD Instructions
Running the Boot Floppy Disk Restore on the CV60
Note: The network recovery boot menu will prompt
you to enter the user name and password. If the user
name is correct, press Enter to continue.
1 Plug a USB floppy disk drive to one of the USB ports on the
CV60.
a Check the BIOS settings for floppy disk boot.
b Press [F2] to enter the setup.
c Make sure the setting is at the top of the Boot list.
2 Place the boot floppy disk into the USB floppy disk drive.
3 Boot the CV60.
4 The recovery process will prompt you for user name and pass-
word list. If you create a password list, the next time you boot
from the floppy, it will not ask you for user name and pass-
word again.
5 The CV60 loads the Symantec Ghost Utility from the network
location you specified in the Boot Disk Builder menu.
6 When the restore is finished, power off the CV60 and remove
the USB floppy drive.
7 Power the CV60 back on. Your image should be restored.
Restoring an Image on the CV60 (Using the CD-ROM)
1 Plug a USB CD-ROM drive to one of the USB ports on the
CV60.
a Check the BIOS settings for CD-ROM boot.
b Press [F2] to enter Setup.
c Make sure the CD-ROM Drive setting is at the top of the
Boot list.
2 Place the Recovery Tools CD into the USB CD-ROM drive.
3 Boot the CV60.
4 The CV60 will load Symantec Ghost Utility from the CD-
ROM and restore the image.
To Next Page
Loading...
