10 CV60 Vehicle Mount Computer Quick Start Guide
External Keyboards
• PS/2 interface with locking connector
External Mouse
• Off-the-shelf USB mouse
Audio
• Internal Speaker (mono)
• Stereo Line out/Headset Jack
• External microphone jack allows voice recording. (Mutes
internal speaker when connected.)
Troubleshooting
CV60 Computer does not respond to applying power.
Check to ensure that your CV60 Computer is connected to the
correct power source.
CV60 will not turn on when the On/Off button is pressed.
• Check the power supply connectors and cabling from the
CV60 Computer.
• Check the connections from the dc power supply and verify
that the green LED is lit.
CV60 shuts down during operation.
• Check the power supply cable(s) for intermittent operation by
moving or jiggling it.
• Check to see if the green LED on the back of the power supply
is flickering or blinking at the moment the CV60 Computer
shuts down.
• Check your installation, cables, etc. Flickering LEDs indicate
the power supply has encountered an over-voltage, over-cur-
rent, or over-temperature event. See the Vehicle Power Supply
Installation Guide (P/N: 932-003-001) for more information.
CV60 does not turn off
• May not turn off when it is processing data.
• In the event that your vehicle mount computer locks up, hold
the on/off button down for approximately 4-5 seconds. This
causes an emergency forced shut down of the computer.
• Remove the DC power input and wait 20-30 seconds before
reconnecting.
To Next Page
Loading...
