4 CV60 Vehicle Mount Computer Quick Start Guide
4 Make sure the cable is not pinched or rubbed by any moving
parts on the vehicle.
Windows CE .NET
1 Enable Bluetooth™ settings by selecting Start > Settings >
Control Panel > Local Bluetooth. Tap Tu rn O n if you see the
“Bluetooth is off” message, check Connectable, then tap OK.
2 Select Start > Run, then browse to Program Files > Intermec
> Network >BluetoothScannerWizard.exe to associate your
scanner with the CV60 Computer.
3 Tap Add Device, then tap Quick Connect (Incoming) to have
the Connection Wizard find your scanner.
4 Scan the bar code, then tap Finish to exit. After association,
enter PIN “0000” in the Authentication dialog box.
Note: If you have any problems scanning the bar code
shown on the display, you can also scan the Bluetooth
association bar code label on the side of the CV60
Computer.
To Next Page
Loading...
