Intermec EasyCoder PD41 Safety Instruction

EasyCoder PD41 Printer Safety Instructions 1
Safety Warnings
Safety Warnings
• Read and review the warnings in this manual carefully before
connecting the printer.
• Moving parts are exposed when the side door is open, so ensure that
the door is closed before you operate the printer.
• Do not open the front/left-hand cover. Dangerous voltage!
• Do not remove the bottom plate. Dangerous voltage!
• Caution: Double pole/neutral fusing
• Do not put your fingers inside the print mechanism when the power
is on.
• Place the printer on an even surface which can support its weight of
approximately 13 kg (28.7 pounds) plus supplies.
• Do not spray the printer with water. If you are using a hose to clean
the premises in an industrial environment, remove the printer or
protect it carefully from spray and moisture.
• Carefully read the warning text on the envelope before using a
cleaning card.
Product Identification
e machine labels are attached to the printer’s rear plate and contain
information on type, model, and serial number as well as AC voltage.
is document provides warnings regarding personal safety during
operation of the printer.

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g