Intermec PM4I - Label Length; Label Width; Line Analyzer; Log to Card

14 ZSim v5.XX User‘s Guide
Label Length
Purpose: Specifies the length of the labels in [inches] or [mm]
depending on the units selected. is parameter
is automatically set during the Initial Setup
Configuration process.
Note:
You can only set the label length if the Media
Type is set to Continuous.
Label Width
Purpose: Specifies the width of the label in [mm] or [inches].
You should set the width to prevent labels from being
printed outside of the printable area, which may harm
the printhead.
Default:
Full width of printhead:
EasyCoder PF2i: 56 mm (2.2 inches)
EasyCoder PF4i & PM4i: 104 mm (4.1 inches)
EasyCoder PX4i: 112 mm (4.5 inches)
EasyCoder PX6i: 166 mm (6.6 inches)
EasyCoder PD41: 104 mm (4.1 inches)
Line Analyzer
Purpose: Determines whether to print received data on the
label.
Default:
Off
Log to Card
Purpose: Logs the received data to a file on a CompactFlash
card. You can use the log file for later analysis.
Default:
Off
LTS
Purpose: Turns the label taken sensor (LTS) on or off.
Default:
Off
Media Contrast
Purpose: Adjusts the darkness and contrast of the printout.
You can adjust this value from 0 to 30. Has influence
only on the Fingerprint setup parameter “contrast.”
A value of 15 corresponds to the Fingerprint contrast
value 0%.