The handstrap (P/N 825-196-xxx) provides you with a convenient way to carry your
PW50 printer. The handstrap kit contains these items:
• Handstrap accessory
• These instructions
To attach the handstrap
1 Release the strap from the adjuster, and remove the strap from the VELCRO
pad.
2 Insert the strap through the PW50 and VELCRO pad. Make sure the D-ring and
adjuster are oriented as shown at the top of the PW50.
PW
50
Handstrap Instructions
Note: VELCRO is a trademark of Velcro Industries B.V.
Strap
D-ring
Adjuster
VELCRO pad
To Next Page
