Interpump Group IP - Maintenance; Oil Change

22
10.1 - OIL CHANGE
10 - MAINTENANCE
• Maintenance and repairs should always be performed by trained and authorised personnel.
• Before carrying out any cleaning, maintenance and/or parts replacement, disconnect the
machine from the power mains, removing the plug from the power outlet.
• Proper maintenance favours a longer duration of operation and improved performance.
• Periodically check the conditions of the washer, pressurised parts (pipe, fittings, lance) and
the electrical cable (see "General warnings for use").
Check for any water or oil leaks and/or malfunctions.
If necessary, replace affected parts.
The list of specific machine components and circuit diagrams are contained in the booklet
"SPARE PARTS NOMENCLATURE".
Contact Interpump Group customer service in the event of any doubts.
• The oil level must be checked periodically through the oil sight glass (only IPX series)
• Oil must be changed after the first 50 hours of operation of the machine. Subsequent oil
changes must be carried out every 300 hours of machine operation.
• In any case it is advisable to change the oil at least once a year.
• Oil type: SAE 15W40 Mineral.
IPX SERIES
OIL capacity: 0,4 liters
• Unscrew the drain plug on the bottom of the pump and the black/yellow dipstick on top.
• Collect the used oil in a tank and convey it to an authorized collection center.
• Replace the drain plug and fill in the oil up the level as shown in the oil level gauge.
• Replace the black/yellow dipstick.
IPX
IPX