10
• When the called party answers the phone, continue to speak using
microphone in the telephone or pick up the Handset. While the Handset
is in use it is possible to revert to speakerphone by pressing the
Handsfree/Headset button BEFORE replacing the Handset.
Note: if using the Handset and the Handsfree/Headset button is pressed to
revert to speakerphone operation, both the Handset and the speakerphone
microphones are muted until the Handset is replaced.
• The call is terminated by replacing the Handset on the cradle or by
pressing the Handsfree/Headset button.
The telephone will continue to ring an unanswered number until the call is
terminated by pressing the Handsfree/Headset button.
When the Headset is connected, the Handsfree function is disabled to allow
the Headset/Handsfree button to work in Headset mode.
Press the Handsfree/Headset button firmly and dial out tone will be heard in
the Headset. Dial the required number on the keypad.
Memory Storage / Dialling
This telephone can store ten memories. The numbers are stored in Flash
memory which means that they will never be lost.
To store numbers, ensure that the telephone is connected to the line.
• either lift the Handset or press the Handsfree/Headset button
• press the Store button
• dial the number to be stored using the keypad
• press the Store button again
• press the Memory button where you want to save the number
• replace the Handset or press the Handsfree/Headset button to clear the
line.
To Next Page
Loading...
