Intex 26339EH - Auto Cleaner Setup and Connection

(198PO) AUTO CLEANER ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 07/08/2021
198
PO
S AVE THESE INSTRUCTIONS
Page 5
Please read, understand, and follow all instructions carefully before
installing and using this product.
General
• TheAutoCleanermustbeconnectedtoafilterpumpwithaflow 
rate between 1600 - 3500 gallons/hour (6056 - 13248 liters/hour).
• ForIntex
®
above ground pools with 1-1/2” (38 mm) threaded
strainer connector hose fitting.
• Thecleaningperformancedependsonthefilterpumpflowrate, 
the higher the flow rate the better the performance.
• Firstassembleyourfilterpumpandthensetuptheautocleaner.
• Ifusingasandfilter,ensurethesandmediaiscleanby
backwashing it first. Run the filter pump for 10-15 minutes before
connecting the auto cleaner to the water return connector.
• Theautocleanerwillnotworkifthefilterpumpisnotoperating.
IMPORTANT PREPARATION INFORMATION
SETUP INSTRUCTIONS