(198PO) AUTO CLEANER ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 07/08/2021
198
PO
S AVE THESE INSTRUCTIONS
Page 8
5. Brush assembly. See Fig. 5.
NOTE: Remove the brushes from underneath the device when
vacuuming large debris or leaves on the pool floor.
6. From outside of the pool, connect the end of hose with the hose
collar nut (8) to the auto pool cleaner inlet.
Vertically insert the hose collar nut (8) into the inlet opening, while
pushing down the hose collar nut, turn the inlet rim clockwise
to tighten the hose. To remove the hose, turn the inlet rim
counter-clockwise. See Fig. 6.
5
10
11
6
Press
Clockwise direction Screw
SETUP INSTRUCTIONS (continued)
To Next Page
Loading...
