(198PO) AUTO CLEANER ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 07/08/2021
198
PO
S AVE THESE INSTRUCTIONS
Page 10
1. Make sure the filter pump is turned
off, and disconnect the power cord
from the electrical outlet.
2. Lift the auto cleaner’s hose slowly
then hold the auto cleaner up with
both hands. See Fig. 9.
CAUTION: Do not pull the hose
directly which could damage the
auto cleaner hose connection fitting.
3. Grasp the cleaner base with two
hands, lift the auto cleaner up slowly
with an angle (either head or tail up).
See Fig.10. After the water has been
fully released from the auto cleaner,
carry the auto cleaner out of the
pool and put it on the ground.
4. Unlock the four buckles located on
the four sides. See Fig. 11.
5. Remove the debris net (4) from the
cleaner base (5). If debris is on the
debris net and cleaner base, use
garden hose to flush the debris off.
See Fig. 12.
6. Reassemble auto cleaner reversing
steps 1, 2, 3, 4 and 5.
10
11
9
(1)
(2)
12
4
5
DEBRIS NET CLEANING
To Next Page
Loading...
