Intex 26339EH - Auto Cleaner Troubleshooting

(198PO) AUTO CLEANER ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 07/08/2021
198
PO
S AVE THESE INSTRUCTIONS
Page 12
If you continue to experience difficulty, please contact our Consumer Service Department
for assistance. See separate “Authorized Service Centers” sheet.
IMPORTANT
TROUBLESHOOTING GUIDE
AUTO CLEANER
DOESN’T MOVE
MOVEMENT IS
VERY SLOW
LIFTS OFF FROM
THE POOL FLOOR
CAN NOT PICK UP
THE LEAVES ON
POOL FLOOR
TROUBLE SOLUTION
• Ensurethefilterpumpisoperating.Lifttheautocleaner
out of the water and check if water is flowing out from
either end of the device.
• Tightenhoseandhosecollarnutsecurely,andconnect
the hose to the water return connector, see “Setup”
section. If you are not sure which return connector is,
try connecting the auto cleaner to each pool outlet until
water is flowing out of either end of the device.
• Lifttheautocleaneroutofthewrinkledarea,andmake
sure the pool floor is as smooth as possible.
• ContactIntexServiceCenter.
• Checkandcleanthedebrisnetandmicro-screen.
• Cleanorreplacethefilterpumpcartridge.
• Ifusingasandfilter,ensurethesandmediaisclean
by backwashing it. See sand filter owner’s manual.
• Ifyouarestillnotsatisfiedwiththespeed,ahigherflow
rate filter pump is recommended.
• Releasetheairfromtheautocleanerbyfollowingthe
“Setup” instructions.
• Poolwatertoodirty.Ensurethepoolwaterchemistry
is balanced. If the pool water is green, brown or black,
adjust the chlorine and pH level. See pool owner’s
manual.
• Checkifthepumpflowrateiswithinthespecified
range, if the flow rate is more than 3500 gal/h, change
pump with lower flow rate.
• Removethebrushesfromtheundersideandputthe
Auto Cleaner back into the pool, see “Setup” section.
• CleanallthedebrisfromtheAutoCleanerafter
operating for 2-3 hours continuously.