345
A
SAVE THESE INSTRUCTIONS
(345IO) SAND FILTER PUMP COMBO ENGLISH 7.5” X 10.3” PANTONE 295U 04/10/2022
English
Page 19
OPERATING INSTRUCTIONS (continued)
To view the TIMER preset hours:
While the pump is operating, press
button, the display will briefly flash the preset hours for
10 seconds and then display back the remaining operating hours.
To operate the sand filter pump manually (without the ʺTIMERʺ
mode):
1.
To run the pump alone without the ʺTimerʺ, press
button to turn
on the pump, then press
button until the LED displays ʺFPʺ,
this indicates that the TIMER is off and the pump is now operating
continuously.
2.
To stop the pump, press
button again.
Set operating hours for the chlorinator mode:
1.
Press
button to unlock the keypad.
With LED flashing, press button to
set the desired operating hours. See the
ʺOperating Time Tableʺ for the required
operating hours related to each pool
size. Pressing
will increase the
time from 00 to 12 hours maximum. If
you have selected too many hours keep
pressing to repeat the cycle. The built-in timer will now activate your chlorinator mode,
at the same time each day, for the number of hours you have set.
2.
With the desired hour value showing, press
button to lock the keypad controls. The
chlorinator indicator light is up when activated. The system is now starting chlorine sanitizer
production and will stop after the operating hours are completed.
NOTE:
If you forget to lock the keypad controls, the system will automatically lock it and start
working 10 seconds later.
3.
The system in chlorinator mode will activate the pump automatically, the LED will always
first display the remaining chlorinator hours until it’s finished. To check the preset chlorinator
hours, you need to unlock the keypad and press
button.
4.
To stop the chlorinator mode, press
button to unlock the keypad controls, then press
button and reset the hour to ʺ00ʺ.
NOTE:
If the chlorinator and the filter pump are in timer mode and the chlorinator timer is set
longer than the filter pump timer, the filter pump timer will automatically change to the same
time as the chlorinator set time.
(0 to 12 hours max per cycle)
To Next Page
Loading...
Need help?
General
