Intex Greywood Deluxe - Page 17

346
NL
S AVE THESE INSTRUCTIONS
(346NL) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 08/09/2019
English
Page 17
OPERATION (continued)
Heater Duration Timer (HDT) Button:
Use this button to select the desired length of time
the heating system should operate. Press this button and then press or to set the
number of hours you wish the heater to operate before it automatically turns off, from 000 to
048 hours. The icon will fl ash red for a few seconds and then stays red. The heating system
will operate for the amount of preset hours only. The timer takes priority over temperature,
so the heater will shut off when HDT time runs out regardless if the preset spa water
temperature is reached or not. During the HDT function, the information shown on the LED
display alternates between the remaining heater operating hours and the water temperature.
Repeat previous steps to reprogram this function. To deactivate the function at any time,
simply set the HDT time back to 000. To readjust the preset hours, press the HDT button
twice and adjust the hours with
and buttons.
Example 2:
Using the same scenario as example 1 above but rather than manually turning
the heater off when you are fi nished, you would like the heater to turn off automatically on
Saturday evening at 9:00pm. After going through the steps in example 1, press the HDT
button and then the
or button to select 048 hours. The heater will then run from
Thursday at 9:00pm to Saturday at 9:00pm.
NOTE:
If HST and HDT timers are both set, the LED display will fi rst alternate between
remaining time before the heater start and the water temperature, until HST timer runs out
and the heater activates. Then the LED display alternates between remaining HDT time and
water temperature until the HDT timer runs out as well.
Adjustment Buttons:
Press the increase or decrease buttons to adjust the desired function
settings. Press and hold the button will rapidly increase or decrease the numbers.
LED Display:
Once plugged in the LED displays the current water temperature automatically.
If the control panel
(5)
is not placed on the control base recessed channel, the LED display
will go blank after 5 minutes. Press any button to resume the control panel.
I: Heater Duration Timer (HDT) Button
J: Decrease Button
K: Increase Button
L: LED Display
SPA CONTROL PANEL
K
J
L
I