347
A
S AVE THESE INSTRUCTIONS
(347IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/08/2020
English
Page 11
SET UP (continued)
Take out the ground cloth and spread it over the cleared area. Then spread out the spa liner over
the ground cloth and point the drain valve towards a suitable draining area.
Spread the ground cloth with the bubbles facing down over the cleared area where you intend
to setup your spa.
Flip up the control base side coverto reveal the air blower ination outlet. Pull out the latch to open
the cover, insert the hose adaptor with hose and reattach the latch to the hose adaptor to secure it
in place .
Unscrew the air valve cap on the spa tub to reveal the stem in the
up position for ination. Insert the other end of the ination hose
into the valve and turn to the right to lock it in position (see
.
2
2
Depending on local building codes and regulations, have a qualied electrician to connect the spa
equipotential terminal with a conductor (wire) having a nominal cross-sectional area of 2.5 mm
2
to 6mm
2
to
the household equipotential terminal. (Wire not included)
2
To Next Page
Loading...
