347
A
S AVE THESE INSTRUCTIONS
(347IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/08/2020
English
Page 16
LED CODE CHART
No water ow
• Turn o and unplug the control unit.
• Ensure the outlet cover grid is clean and free
from obstructions.
• Clean or replace the cartridge, see
Maintenance and Storage section.
• Ensure the in/outlet connections on the spa tub
and lter pump are not blocked.
• Keep the spa water properly sanitized to
ensure a clean and unclogged lter cartridge.
• If problem persists, contact Intex Service
Center.
Water temperature too low
• If the ambient temperature is below 4°C (39°F),
we recommend not to use the spa.
• Turn o and unplug the control unit, add some
warm water to raise the spa water temperature
above 5°C (41°F), then press the
button to
heat up the water to the desired temperature.
• If problem persists, contact Intex Service
center.
Water temperature too high
• Turn o and unplug the control unit. When the
water has cooled down, plug the RCD and
restart all over again.
• Turn the heater o, then press the lter and
bubble buttons to lower the water temperature.
• If problem persists, contact Intex Service
Center.
System Error
• Turn o and unplug the control unit. Plug the
RCD and restart all over again.
• If problem persists, contact Intex Service
Center.
Dry-re Protection • Contact Intex Service Center.
Water temperature sensor broken • Contact Intex Service Center.
After 72 hours of continuous
heating operation, the pump will
hibernate automatically. The rapid
heating and water ltration
functions are disabled.
• Press the
button to re-active the
lter pump.
To Next Page
Loading...
Need help?
General
