347
A
S AVE THESE INSTRUCTIONS
(347IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/08/2020
English
Page 22
MAINTENANCE (continued)
In regions subject to freezing temperatures, drain, clean, disassemble and properly store the spa set and related
components indoors when the temperature drops below 4°C (39°F).
Drain and clean the spa following the “Spa Tub Drainage” and “Spa Tub Cleaning” sections.
Reverse set up instructions to deate and disassemble the spa tub, spa control unit and spa cover air
bladder.
To deate the tub and the cover air bladder:
a) Open the deation outlet cap with the included bolt
wrench .
b) Insert deation hose adaptor into the deation outlet.
c) Insert ination hose over the deation hose adaptor .
d) Insert the other end of the ination hose into the tub air valve
or cover air bladder valve.
e) Press the air bubble
button to deate.
f) When deation is completed reverse above steps and
ensures the deation outlet cap is securely fastened.
Only use for the purpose described in this manual.
Keep the ination hose away from water or small objects when the
deation function is activated to avoid damage to the blower motor.
Make sure all the spa components and accessories are thoroughly
clean and dry before storage. Air-dry the spa tub in the sun for an
hour before folding.
Fold the spa tub loosely and avoid any sharp corners to prevent
damage or leakage to the spa tub liner.
Prepare additional new cartridges for next time use.
Store the spa tub and accessories indoors, in a dry, temperature controlled, between 0º – 40ºC
(32º – 104ºF), storage location.
The original packing can be used for storage.
STORAGE
Barefoot areas and relaxing areas around the spa shall be cleaned on a regular basis. No cleaning water may
ow into the spa or spa water cycle. The dirt and cleaning agents shall be rinsed carefully to drain in the spa
surround.
Use the enclosed repair patch to repair any puncture:
• Clean and dry the area to be repaired thoroughly.
• Remove the patch backing paper and press patch rmly over the puncture. Smooth out the surface to
remove any air bubbles under the patch.
2
To Next Page
Loading...
