(130GS) MINI SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/09/2022
130
GS
SAVE THESE INSTRUCTIONS
English
Page 12
LED CODE CHART
Some countries, especially in the European community, require the product to be secured to
the ground or to a base in a permanent upright position. Check with your local authorities to
determine if there is a regulation in your area regarding above-the-ground swimming pool fi lter
pumps. If yes, then the product can be mounted to a platform using the two holes located in the
base. See drawing below.
The product can be mounted on a cement base or onto a wooden platform to prevent accidental
tipping. The mounting holes are 6.4 mm in diameter. Total assembly must exceed 18kg.
IMPORTANT
When Code “90” alarm is shown, ensure the timer of the filter pump is set
one (1) hour longer than the Saltwater System.
If the filter pump does not have a built-in timer, the filter pump needs to
be turned on/off manually every day.
LED Reading Definitions
00 Stand-By Mode (Start-up)
01 Minimum Operating Hour (1 hour remaining)
02 - 11 Operating Hours (2 - 11 hours remaining)
12 Maximum Operating Hours (12 hours remaining)
90 Alarm Code (Low Pump Flow / No Flow)
91 Alarm Code (Low Salt Level)
92 Alarm Code (High Salt Level)
93 Stand-By Mode (Operating Process finished)
“BLANK”
No Power or “Power Saving Mode” waiting to start next
Saltwater System cycle.
SALTWATER SYSTEM STATIONARY MOUNTING
52 mm
To Next Page
Loading...
Need help?
General
