348
PO
S AVE THESE INSTRUCTIONS
(348PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/25/2019
English
Page 10
SET UP (continued)
5.
Press the button again to turn it off.
6.
After ination, if the horizontal top seam of the external lining
(32)
is not aligned with the spa tub
(16)
horizontal top seam
(see drawing 5)
, let some air out of the the spa tub, then adjust the external lining
and re-inate the spa tub.
7.
Replace the air valve cap back.
The cap is designed to be screwed on and off. Never exert force
as this could cause the complete internal ination system of the
valve to come loose. See “Spa Tub Air Valve Fastening” for valve
maintenance.
NOTE:
If there is a need to replace the spa tub air pressure release
valve core
(23)
due to wear and tear, use the included wrench
(22)
to
unscrew the core from the valve base. Insert the replacement core and
tighten with the wrench. Make sure the core is securely tightened
(see drawing 6)
.
4.2
IMPORTANT:
To prevent damage to the air blower motor never
block the air blower outlet opening during ination.
6
22
23
5
To Next Page
Loading...
Need help?
General