Intex SimpleSpa SB-B20 User Manual

348
A
S AVE THESE INSTRUCTIONS
(348IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/09/2019
English
Page 15
OPERATION
SPA CONTROL UNIT PANEL
On/Off Button:
Once the unit is plugged in, use this button to active the control unit panel
buttons. The light next to the button is green when activated. Press this button to turn off all
currently activated functions.
NOTE:
The On/Off button may appear as a black button in the center of the control panel.
Heat Button:
Use this button to activate the heating system. The pump will heat the spa water
until the water temperature reaches the set temperature. When the spa water temperature drops
1-2°C (1.8-3.6°F) below the set temperature the heating system will restart.Whentheameicon
  onthedisplayisred,theheatingsystemisactivated.Whentheameiconturnsgreen,the
  waterisatthesettemperature.Theheatingsystemisatrestandtheltrationsystemwill
continue working nonstop.
NOTE:
Tostoptheltrationsystemwhiletheheaterisatrestmode,presstheamebuttonrst
  andthenthelterbutton.Pressingtheamebuttononlywhiletheheaterisatrestmodewill
  turnofftheheatingsystemonlyandtheltrationsystemwilloperateforanother24hoursbefore
it turns off automatically.
IMPORTANT:
The following conditions will lead to slow water heating.
• The ambient temperature is lower than 10ºC (50ºF).
• Outdoor wind speed is above 3.5-5.4 m/s (8-12 mph).
• The air bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
Celsius/Fahrenheit Toggle button:
The temperature can be displayed in either Fahrenheit or Celsius. The system’s default is
Celsius.
NOTE:
The default temperature is 20°C (68°F). Temperature adjustment ranges from 20°C (68°F)
to 40°C (104°F).
Temperature Adjustment Buttons:
Pressing the Temperature Increase or Decrease
  buttonswillcausetheLEDtoash.Whenashingyoucanadjusttothedesiredtemperature
setting. If you hold these buttons down the values will rapidly increase or decrease. The new
  anddesiredtemperaturesettingwillremainontheLEDdisplayfor5secondstoconrmthenew
value.
Water Filter Button:
Thisbuttonturnsthelterpumponandoff.Iftheheatingsystemisactivatedtheltration
system will automatically start.
  Thewaterltericononthedisplayisgreenwhenactivated.
Bubble Button:
Use this button to activate the massage system, which has a 30-minute
auto-shutoff feature. The bubble icon on the displays is green when activated.
CAUTION:
Do not run Bubble system when the cover is attached, air can accumulate
inside the spa and cause irreparable damage and bodily harm.
LED Display:
Once plugged in the LED displays the current water temperature automatically.
A: Heat Button
B: Celsius/Fahrenheit Toggle Button
C: Temperature Increase Button
D: Temperature Decrease Button
E: Water Filter Button
F: Bubble Button
G: LED Display
H: On/Off Button
40
C
o
F
E
D C
B
A
G
H
WARNING
NEVER use the spa if indicated water temperature is more than 40°C (104ºF).

Intex SimpleSpa SB-B20 Specifications

General

Brand	Intex
Model	SimpleSpa SB-B20
Category	Hot Tub
Language	English