Intex SimpleSpa SB-B20 User Manual

348
A
S AVE THESE INSTRUCTIONS
(348IO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/09/2019
English
Page 24
TROUBLESHOOTING (continued)
PROBLEM CAUSE SOLUTION
TUB LOSES AIR
PRESSURE
• Air valve cap loose.
• Air valve base loose.
• Hole, cut or split on spa tub.
• Ensure air valve cap is securely closed.
• Fill up the spa tub with air then make sure the
air valve base is tighten, see “Spa Tub Air Valve
Fastening” section.
• Put liquid soap and water in a squirt bottle and
spray on seams. If there is a leak it will bubble.
Afteryoundtheleak,cleananddrytheleaking
area, then apply the repair patch that comes with
your spa.
LEAKING BETWEEN
SPA TUB
CONNECTORS AND
CONTROL UNIT
CONNECTORS
• Spa control base inlet/outlet
connections not securely tight.
• Spa control base inlet/outlet o-ring
missing/dirty.
• Tighten inlet and outlet connections.
• Coat the o-ring with petroleum jelly for water
proof.
• Remove grid from inside spa with a screwdriver,
ensure inlet/outlet O-ring is in place, clean and
not damaged.
SPA IS TOO NOISY
IN FILTRATION
MODE ONLY
• Control base components not
securely attached.
• Control base ground not level and
rm.
• Spaltermotorfailed.
• Ensure control panel, back cover and all inlet/
outlet are securely connected.
• Ensuregroundislevel,rmandsmooth.
• Replacethefailedltermotorwithanewone.
AIR PRESSURE
IS WEAK DURING
INFLATION
• Hose adaptor o-ring missing.
• Inationhoseadaptornotsecurely
tighten.
• Connection between the hose
adaptorandblowerinationoutlet,
andbetweentheinationhoseand
inationvalveareloose.
• Air blower failure.
• Ensure the o-ring is in place.
• Tighten/reinstall hose adaptor.
• Fingertightenduringination.
• If problem persists, contact Intex Service Center.
AIR BUBBLES ARE
NOT AS STRONG
AS BEFORE
• O-ring missing between the control
base air outlet and spa tub air inlet
connections.
• Air connection nut is not securely
tight.
• Air bubble channel passage inside
the tub broken or leaking.
• Air blower failure.
• Ensure the o-ring is in place.
• Finger tighten all nuts.
• Use repair patch to repair any puncture.
• If problem persists, contact Intex Service Center.
IMPORTANT
If you continue to experience difculty, please contact our Consumer Service Department for
assistance. See separate “Authorized Service Centers” sheet.

Intex SimpleSpa SB-B20 Specifications

General

Brand	Intex
Model	SimpleSpa SB-B20
Category	Hot Tub
Language	English