To Next PageTo Next Page
Need help?Do you have a question about the Intex Ultra XTR 128927GH and is the answer not in the manual?
This document is an owner's manual for Intex Ultra XTR™ Pools, specifically for models ranging from 14' to 24' (427 cm - 732 cm) in diameter. It provides comprehensive instructions for setup, maintenance, safety, and storage of the pool.
The Intex Ultra XTR™ Pool is an above-ground, frame-supported swimming pool designed for outdoor recreational use. It provides a contained body of water for swimming and other aquatic activities. The pool system includes a liner, a metal frame structure (horizontal beams, vertical legs, T-joints), a ground cloth, and various accessories for water circulation and maintenance. Some models may be purchased with an Intex Krystal Clear™ filter pump, which is crucial for maintaining water quality. The pool is designed for easy assembly and disassembly, allowing for seasonal use and storage.
The manual covers pool sizes from 14' (427 cm) to 24' (732 cm) in diameter, with a consistent height of 132 cm (52"). The parts reference table details the quantities of each component required for different pool sizes, including T-joints (14 to 24), vertical legs (14 to 24), leg caps (14 to 24), horizontal beams (14 to 24), a single pool liner, vertical leg spring pins (14 to 24), a ground cloth, a drain connector, drain valve caps (1 to 2), a pool cover, strainer hole plugs (up to 3 for 14' models, 0 for larger models), and T-joint spring pins (28 to 48). The assembly time is estimated at 45-60 minutes, though this may vary. The pool is designed to be connected to a grounding type receptacle protected by a ground-fault circuit interrupter (GFCI) or residual current device (RCD) if a filter pump is used.
The pool is intended for outdoor use only. It requires a flat, level, and compacted ground surface for setup to prevent collapse and ensure safety. A team of 2-3 people is recommended for setup. The liner is designed to be warmed by the sun before frame assembly to facilitate insertion of beams. During setup, the drain valve should be directed towards the draining area, and hose connections should be oriented towards the electric power source if a filter pump is used. The manual emphasizes the importance of ensuring the pool is perfectly level during filling to avoid structural issues. Users are instructed to smooth out liner wrinkles from inside or outside the pool before full filling. The water level should be filled up to just below the sleeve line. The manual strongly advises against diving, jumping, or sliding into the pool due to its shallow depth. It also recommends keeping rescue equipment and emergency numbers readily available.
Maintaining proper water balance and sanitation is critical for the pool's longevity and user health. The manual advises against direct contact of chlorine with the liner and instructs users to dissolve granular or tablet chlorine in water before adding it to the pool. Chemicals should be added separately and thoroughly dissolved. Intex pool skimmers and vacuums are recommended for cleaning. The filter pump should operate daily to ensure at least one complete turnover of water. Filter cartridges should be replaced every two weeks. The manual includes a troubleshooting guide for common pool problems such as algae, colored water, floating matter, chronic low water level, sediment, and surface debris, offering causes and solutions. For winterization, the pool should be drained, disassembled, and stored in a dry, temperature-controlled area (between 32°F/0°C and 104°F/40°C) if temperatures drop below 41°F/5°C. The liner should be air-dried in the sun and sprinkled with talcum powder before folding to prevent sticking. If the pool is left out in temperatures above 41°F/5°C, it should be cleaned, accessories removed, inlet/outlet fittings plugged, and covered with an Intex Pool Cover (which is not a safety cover). The pump and filter parts should be cleaned, dried, and stored indoors.
The manual highlights several important safety rules, emphasizing continuous and competent adult supervision, especially for children and disabled individuals. It recommends installing a safety barrier to prevent unauthorized access. Users are warned never to dive, jump, or slide into the pool. The pool must be set up on flat, level, compact ground to prevent collapse. Electrical connections for filter pumps must be to a GFCI/RCD protected outlet, and extension cords, timers, or plug adapters should not be used. Children should be kept away from pool covers to avoid entanglement. The pool water must be kept clean and clear, with the floor visible at all times. Good hygiene and proper water sanitization are crucial to prevent recreational water illnesses. The manual also advises against assembling the pool in high wind conditions and using alcohol or medication while swimming. A limited warranty of 2 years covers the pool liner and frame against manufacturing defects, provided proper use and maintenance instructions are followed.
General| Brand | Intex |
|---|---|
| Model | Ultra XTR 128927GH |
| Category | Swimming Pool |
| Language | English |
