16
WARNING
DO NOT change the L/min. setting on the flowmeter
unless a change has been prescribed by your physician or
therapist.
NOTE: To properly read the flowmeter, locate the prescribed flowrate line on
the flowmeter. Next, turn the flow knob to until the ball rises to the line. Now,
center the ball on the L/min. line prescribed.
FIGURE 5 - ADJUSTING THE FLOWRATE
SENSO
2
® OXYGEN PURITY INDICATOR-IF YOUR
UNIT FEATURES THE O2 SENSOR FEATURE
This feature monitors the purity of oxygen generated by the oxygen
concentrator. If purity falls below factory preset standards, indicator
lights on the control panel will illuminate.
Ball
Flow knob
POWER SWITCH
1. Press power switch to the ON position. The power light (I/O),
located on the control panel, will illuminate a GREEN light. The
alarm will "beep" three (3) times indicating that the system is
functioning properly.
FLOWRATE
1. Turn the flowrate knob to the setting prescribed by your physician
or therapist.
OPERATION / MAINTENANCE
To Next Page